Email this article Automatic Measuring And Recompense System For Monitoring Health Management Process For Automobiles
Abstract
In this projected project work, numerous physical systems detector readings will be measured and by standardization different system performs will be foreseeable. The project uses to ARM core with a will bus communication. From the engine half ARM core, the detector readings are unendingly transmitted to the dash board half ARM core. In dash board, the brink comparisons are done and detector failure also can be known. Victimization reserve and also the engine speed, we expected distance to that the vehicle will go. If any hardware system is failing within the vehicle means that, by load current we will establish the fault. . The dash board show provides hassle shooting info to the user. By this project work we will maintain the health of Associate in Nursing automobile system to increase level.
References
Karl Henrik Johansson, Martin Törngren, and Lars Nielsen,“Vehicle Application of Controller Area Networkâ€.proc ofThe Handbook of Networked and Embedded Control SystemsControl Engineering, 2005, VI, pp.741-76
Renjun Li, Chu Liu and Feng Luo, “A Design for AutomotiveCAN Bus Monitoring Systemâ€, IEEE Vehicle Power and Propulsion Conference (VPPC), September 3-5, 2008, Harbin,China
CAN specification version 2.0. Robert Bosch GmbH, Stuttgart,Germany, 1991.
Wilfried Voss, “A Comprehensible Guide to J1939â€, Published by
Copperhill Technologies Corporation
Steve Corrigan, “Introduction to the Controller Area Networkâ€,Published by Texas Instruments Application Report,SLOA101A,August 2002–Revised July 2008
O. González, M. RodrÃguez, A. Ayala, J. Hernández and S. RodrÃguez, “Application of PICs and microcontrollers in the measurement and control of parameters in industryâ€, Proc of theInternational Journal of Electrical Engineering Education 41/3,pp.265-274, Feb 2001
Microchip Technology Inc. DS41159E: PIC18FXX8 Data SheetPat Richards, “A CAN physical layer discussionâ€, MicrochipTechnology Inc. DS00228A
Dogan Ibrahim, “Microcontroller based temperature monitoring and controlâ€, ISBN: 0750655569, Elsevier Science & Technology Books
P.M. Knoll and B.B. Kosmowski, “Liquid crystal display unit forreconfigurable instrument for automotive applicationsâ€, Opto-Electronics Review, 10(1), 75 (2002)
MCP 2551 High speed CAN Transceiver Datasheet.
National Semiconductor, “LM35 Precision Centigrade Temperature
Refbacks
- There are currently no refbacks.
Copyright © 2013, All rights reserved.| ijseat.com
International Journal of Science Engineering and Advance Technology is licensed under a Creative Commons Attribution 3.0 Unported License.Based on a work at IJSEat , Permissions beyond the scope of this license may be available at http://creativecommons.org/licenses/by/3.0/deed.en_GB.
Â