Email this article Control of the Output Voltage of the PV System Based DC-DC Boost Converter Using Arduino microcontroller
Abstract
The main object of this paper is to design and implement a DC-to-DC boost converter that regulates output voltage to a desired value and can be used in Photovoltaic system appliances or other unregulated sources. To regulate the output voltage of the boost, a feedback loop with Proportional-Integral-Differentiator (PID) controller is employed. The duty cycle is controlled to produce constant output voltage using voltage mode control technique. A simulation of the boost converter is done in MATLAB/Simulink. Also a practical implementation with the help of Arduino microcontroller is confirmed the validity of the control algorithm. Simulation and practical results have been proven that the proposed design is able to produce a regulated output voltage successfully against variation of input voltage and load.
References
A. Kalirasua, S. S. Dash, "Implementation of an Embedded Controlled High Efficiency Improved Boost Converter for Solar Installation System", International Journal of Smart Grid and Clean Energy, Vol. 2, No. 2, pp. 177-183, 2013.
P. Sathya and R. Natarajan, "Design and Implementation of 12V/24V Closed loop Boost Converter for Solar Powered LED Lighting System", International Journal of Engineering and Technology (IJET), Vol. 5, No. 1, pp. 254-264, 2013.
H. Yao, "Modeling and Design of a Current Mode Control Boost Converter", Master thesis, Colorado State University Fort Collins, Colorado, 2012.
S. B. Santra, "Design and Implementation of UPFC based Boost Converter for Efficiency Optimization of Brushless DC Motor Drive System", Master thesis, Jadavpur University-Kolkata, 2012.
G. Ofualagba, I. K. Charles and O. A. Okiemute, "Optimizing the Output Current for a DC-DC Converter", Control Theory and Informatics, Vol. 2, No.2, pp. 49-61, 2012.
L. Guo, "Design and Implementation of Digital Controllers for Buck and Boost Converters Using Linear and Nonlinear Control Methods", Ph.D. thesis, Auburn University, Alabama, 2006.
S. KASAT, "Analysis, Design and Modeling of DC-DC Converter Using Simulink", Master thesis, Oklahoma State University, India, 2004.
K. J. Astrom and R. M. Murray, "Feedback Systems, An Introduction for Scientists and Engineers", Princeton University Press, William Street, USA , ISBN-13: 978-0-691-13576-2, 2009.
K. Ogata, "Modern Control Engineering", Prentice Hall, Fifth Edition, ISBN-10: 0-13-615673-8; 2010.
"ATmega328P Data Sheet", Atmel Corporation, 2009. pdf online: http://www.atmel.com/images/atmel-8271-8-bit-avr-microcontroller-atmega48a-48pa-88a-88pa-168a-168pa-328-328p_datasheet_complete.pdfdata sheet arduino.
Refbacks
- There are currently no refbacks.
Copyright © 2013, All rights reserved.| ijseat.com
International Journal of Science Engineering and Advance Technology is licensed under a Creative Commons Attribution 3.0 Unported License.Based on a work at IJSEat , Permissions beyond the scope of this license may be available at http://creativecommons.org/licenses/by/3.0/deed.en_GB.
Â