Email this article Stabilization of Lime Treated Black Cotton Soil with Bamboo Fibre
Abstract
Construction of pavement subgrades for roads and railways on black cotton soil (BC soil) is highly risky on geo-technical grounds because such soil is susceptible to differential settlements, poor shear strength and high compressibility. Chemical stabilization is one of the oldest methods of stabilization of problematic soil. In recent days, it has been investigated that addition of fibers will improve the ductility behavior of the soil there by reducing the development of crack during shrinkage.
This project describes the compaction and strength behavior of Lime treated black cotton soil (BC soil) reinforced with bamboo fibers. The various percentage of lime as 2%, 4%, 6% and 8% was used to find out the optimum value of lime. Bamboo fiber has been randomly included into the lime treated soil at four different percentages of fiber content, i.e. 0.5%, 1% 1.5%, and 2% (by weight of soil). The tests which were carried out are Atterberg’s Limits, Modified compaction test, California bearing ratio test and unconfined compression test. The test result indicates that strength properties of optimum combination of BC soil-lime specimens reinforced with bamboo fibers is appreciably better than untreated BC soil. And also the strength of the mixed soil increases with increase in days. And Cyclic Plate Load tests were carried out for the optimum percentage obtained from the above test results and the results were analyzed for the suitability of subgrade under certain loads in a model test tanks under laboratory conditions.
References
A Gens, E EAlsono (1992), “A framework for the behavior of unsaturated expansive clays, Canadian Geotechnical Journal.
Agarwala,V.S and Khanna,J.S (1969),Construction techniques for foundations of buildings on black cotton soils
Akshaya Kumar Sabat (2009), Stabilization of Expansive Soil Using Waste Ceramic Dust
Al-khafaji, Wadi Amir and Orlando B. Andersland “Geotechnical Engineering and Soil Testingâ€
Amu et al. (2005) “Cement and fly ash mixture for stabilization of expansive soil.
Arrora, K. R. (2001), Soil Mechanics and Foundation Engineering. R. D. Holtz and W.D. Kovacs, an Introduction to Geotechnical Engineering. New York: Prentice Hall, 1981,.
Bahler et al. (2007) “Stabilization of expansive soils using lime and class C fly ash.
Baser, O.(2009) “Stabilization of expansive soils using waste marble dust, †Master of Science thesis submitted to Civil Engineering Department, Middle East, Technical University.
Baytar (2005) “Stabilization of expansive soil using the fly ash and desulphogypsum obtained from thermal power plant.
Bhasin et al. (1988) “A laboratory study on the stabilization of black cotton soil as a pavement material using RHA, Bagasse ash, fly ash, lime sludge and black sulphite liquor.
Bolt G.H. (1956), “Physico-chemical analysis of the compressibility of pure clays.
Casangrane, A. “The Structure of Clay and Its Importance in Foundation Engineering,†Journal Bostan Society of Civil Engineers, Vol. 19, 1932.
Chandrasekhar et al. (2001) “characteristics of black cotton soil with stabilizing agents like calcium chloride and sodium silicate in comparison with conventional RHA lime stabilization.
Chen, F. H. (1988), “Foundations on expansive soilsâ€, Chen & Associates, Elsevier Publications,U.S.A.
Das, M. Braja, (1997) “Advanced soil mechanicsâ€
Dayakar et al. (2003) “A laboratory investigation for stabilizing the expansive soil using Silica fume and tannery sludge with percentage variation of solid wastes.
El-Aziz et al. (2004) “The effect of the engineering properties of clayey soils when blended with lime and silica fume.
Gromko (1974) Study of Shrinking and Swelling soil.
Gupta et al. (2002) “Study on the stabilization of black cotton soil using quarry dust.
I.S: 2720, Part VII, (1980), Determination of Water Content Dry Density Relation Using Light Compaction.
I.S: 2720-Part III, Section I (1980), Determination Specific Gravity.
I.S: 2720-Part IV, 1975, Determination of Grain Size Distribution.
I.S: 2720-Part V, 1970, Determination of Liquid Limit and Plastic Limit.
Refbacks
- There are currently no refbacks.
Copyright © 2013, All rights reserved.| ijseat.com
International Journal of Science Engineering and Advance Technology is licensed under a Creative Commons Attribution 3.0 Unported License.Based on a work at IJSEat , Permissions beyond the scope of this license may be available at http://creativecommons.org/licenses/by/3.0/deed.en_GB.
Â